Your headline
Image caption appears here
$49.00
Add your deal, information or promotional text
Menu title
This section doesn’t currently include any content. Add content to this section using the sidebar.
Your headline
Image caption appears here
$49.00
Add your deal, information or promotional text
Subheading
Pick the mount your order was made for and jump to its steps. Each one takes about 15 minutes and a level.
Smooth, flat, clean and dry. Not for textured walls, brick, stone or fabric.
Run painter's tape along the bottom of where the letters go, using a level.
Hold each letter in place to check spacing before you peel. Once it touches the wall, it is set.
Peel the liner and press each letter firmly into place.
Remove the painter's tape and step back. Done.
Run painter's tape along the bottom edge of where the letters go.
Start with the middle letter and work outward so the name stays centered.
Hold the letter in place and fire a small pin nail through each tiny pre-drilled hole. Pin nails are thin enough to all but disappear.
Remove the painter's tape and step back. Done.
Hold the sign level on the wall and mark through each pre-drilled hole with a pencil.
Drill at each mark and tap in a wall anchor (skip the anchor if you hit a stud).
Put the screw through each standoff barrel and drive it into the anchor until the barrel sits snug.
Line the sign's holes up with the barrels and thread a cap through each hole into its barrel, hand-tight. The sign floats about an inch off the wall.
Arrange the letters so you know the spacing.
Hold the backing magnet behind the fabric and set the letter in front so they grip through it.
Magnets come off clean. Store letters flat between events.
Brick, stone, outdoor or anything over 24 inches: tell us about your wall before you order and we'll recommend the right mount.
Customer support: Monday–Friday
Free Shipping Over $150
New products, seasonal ideas and business pricing updates from our studio. No spam.
